I did a make V=99 and did get an kernel and the filesystem. I used rev182. So far, so good. When I booted the new kernel; i get the following error: [from dmesg] b44: b44.c:v2.0 b44 ssb0:0: eth0: Broadcom 44xx/47xx 10/100BaseT Ethernet 00:15:f2:77:d0:c1 b44 ssb0:0: eth0: Link is up at 100 Mbps, full duplex b44 ssb0:0: eth0: Flow control is off for TX and off for RX.. Elixir Industries Power Converter Manual Woodworkers there. BCM47xx Watchdog Timer enabled (30 seconds, nowayout) TCP westwood registered NET: Registered protocol family 17 Bridge firewalling registered 802.1Q VLAN Support v1.8 Ben Greear All bugs added by David S. Diag: Detected 'ASUS WL-500g Deluxe' Compat-wireless backport release: compat-wireless-2011-01-31-19-g74d6d79 Backport based on wireless-testing.git master-2011-02-25..

B43-phy0: Broadcom 4306 WLAN found (core revision 5) ieee80211 phy0: Selected rate control algorithm 'minstrel_ht' Registered led device: b43-phy0::tx Registered led device: b43-phy0::rx Registered led device: b43-phy0::radio Broadcom 43xx driver loaded [ Features: PL, GPIO LED Mask: 0x000f, Firmware-ID: FW13 ].. B43-phy0 ERROR: Firmware file 'b43/ucode5.fw' not found b43-phy0 ERROR: Firmware file 'b43-open/ucode5.fw' not found b43-phy0 ERROR: You must go to and download the correct firmware for this driver version. Please carefully read all instructions on this website. Device eth0_lan entered promiscuous mode device eth0 entered promiscuous mode.. If i do an iwconfig or an ifconfig; i see a not configured wlan0 (NO wlan0.monitor) if i do a brctl show; i see no wlan0 (only an eth0_lan interface) when i start hostapd Starting advanced IEEE 802.11 management: hostapdb43-phy0 ERROR: Firmware file ' b43/ucode5.fw' not found b43-phy0 ERROR: Firmware file 'b43-open/ucode5.fw' not found b43-phy0 ERROR: You must go to and download the correct firmware for this driver version. Please carefully read all instructions on this website. Trmdir[ctrl_interface]: No such file or directory failed!